At this point the error message should be correctedand the camera should be displayed with the IP address you just assigned to it. Enter the username and password for the camera and click Ok. Also, the IP address for the camera MUST be different from ALL other devices which are connected to the router.ĥ. Example: If the router’s local IP address is 192.168.1.1 then the IP address range of the camera would be 192.168.1.x with x being between 2 – 254.Verify that the Gateway and DNS server is the router’s local IP address and the camera’s IP address should have the first three numbers as the router’s IP address. Input the appropriate configuration information into every box.Ĥ.Uncheck the check box option “Obtain IP from DHCP from server.Double click the error message Subnet doesn’t match and navigate to Network Configuration. What was also helpful was this page from where you can download the Search Tool to find your camera on your network and change its configurations and use it to upgrade your firmware.
If the above steps do not resolve the error manually assign an IP address for the camera. Once completed the camera will obtain a new IP address from the router’s DHCP server automatically. Verify that the camera and computer are connected to the same router and the router’s DHCP server is enabled.Ģ. This can be caused by the computer and camera not being connected to the same router or the camera was configured with a different IP address on another router.ġ. This error is normally generated because the camera and computer do not have an IP address on the same network segment. Overview: Sometimes while using the Equipment Search Tool newly discovered Foscam cameras will generate an error message Subnet doesn’t match.
0 kommentar(er)
